当前位置：网站首页 > 技术支持
电动伸缩门常见故障 上篇
添加时间：2023/5/27 18:46:38     浏览次数：

1、电动伸缩门电机不能启动：无电源，检查电源是否连接完好。


　　2、熔断器熔断：更换熔器。电容击穿：更换电容。


　　3、超负荷：检查门道轨上是否有障碍物，热保护装置起作用，等20分钟后重新启动。


　　4、感应开关损坏：更换感应开关。


　　5、线路有问题：检查强、弱电线路。


　　6、开关失灵：感应开关位置不正确应调整位置。如是感应开关损坏则要更换感应开关。再者检查COM和L1、L2线是否接错，按线路图正确连接。


　　7、磁钢脱落及位置不对：重新调磁钢位置。


　　8、不能限位：感应开关距离过大，调整感应开关位置。感应开关损坏应更换感应开关。


　　9、手动离合器失灵操纵手柄损坏：更换操纵手柄。


　　10、旋转方向错误；按箭头方向旋转应考虑离合器卡滞。

1, the electric telescopic door motor can not start: no power supply, check whether the power supply is well connected.



2, fuse fuse: replace the fuse. Capacitor breakdown: Replace the capacitor.



3. Overload: Check whether there are obstacles on the door rail, the thermal protection device works, and restart after 20 minutes.



4, induction switch damage: replace the induction switch.



5, the line has a problem: check the strong, weak line.



6, switch failure: induction switch position is incorrect should be adjusted. If the induction switch is damaged, the induction switch should be replaced. Furthermore, check whether COM and L1 and L2 lines are connected incorrectly, and correctly connect according to the line diagram.



7. Falling off and wrong position of magnetic steel: adjust the position of magnetic steel again.



8, can not limit: induction switch distance is too large, adjust the induction switch position. If the induction switch is damaged, replace the induction switch.



9, manual clutch failure control handle damage: replace the control handle.



10. Rotation direction is wrong; Rotation in the direction of the arrow should consider the clutch stuck.
上一页  邢台电动伸缩门常见故障 下篇  
下一页  邢台电动伸缩门故障分析与维修技术